Engine - GM (19433063)

Engine 19433063

Engine - GM (19433063)

Engine 19433063

Buick, GMC, Cadillac, Hummer, Saturn, Oldsmobile, Pontiac, Chevrolet Parts
  • GM
  • 19433063
  • 12682080, 19370671, 19418256

Details

  • Brand:

    Buick, GMC, Cadillac, Hummer, Saturn, Oldsmobile, Pontiac, Chevrolet Parts

  • SKU:

    19433063

  • Description:

    E-ROD SYSTEMS HAVE IT ALL
    Each E-ROD crate engine system carries an official California Air Resources Board (CARB) E.O. number and includes complete emissions equipment, along with the engine controller and harness needed to get the engine running. The primary elements of each kit include:

    • Chevrolet Performance crate engine
    • Engine control module
    • Exhaust manifolds
    • Catalytic converters
    • Mass airflow sensor and sensor boss
    • Oxygen sensors and sensor bosses
    • Air filter
    • Accelerator pedal
    • Evaporative emissions canister
    • Instruction manual
    E-ROD LT1 6.2L SYSTEM
    • CARB EO#: (PENDING)
    • Horsepower: 455 @ 6,000 rpm
    • Torque: 465 lb.-ft. @ 4,600 rpm
    Introduced on the seventh-generation Corvette Stingray and Gen 6 Camaro SS, the LT1 6.2L V-8 opened the next chapter in the long, historic legacy of the Small-Block engine. It is architecturally similar to the LS family of Small-Block engines, but with a unique block casting, cylinder head design, oiling system and more. It also combines advanced technologies including direct injection and continuously variable valve timing to support an advanced combustion system. Chevrolet Performance's new LT1 crate engine - offered with a wet-sump or dry-sump oiling system - and a controller specially designed for retro-fit applications is included. This is the first LT-based E-Rod system and the most technically advanced. It is also available in a Connect & Cruise package with a matched 4L75-E automatic transmission.
    INSTALLATION NOTES
    Engines shipped with high-pressure direct-injection fuel pump installed
    Assembly does not include any electronics
    Kit includes electronic throttle pedal, which is required for throttle input to the ECU
    Intended for pre-1995 street vehicles or any off-road vehicle
    Not intended for marine applications
    Front-End Accessory Drive Kit can be ordered separately
    8-bolt crankshaft flange
    Shipped with 14" flexplate
    BUILDER'S NOTE
    To facilitate a complete E-ROD installation, the builder will need to source additional components to complete the assembly and get the vehicle running, including:
    • Fuel tank
    • Fuel lines (re-circulating or returnless)
    • Fuel pump - 58 psi (400 kPa) for LC9 and LS3 or 65 psi (450 kPa) for LSA
    • Fuel tank vent line from the tank to the evaporative emissions canister
    • Purge line from the canister to the engine purge solenoid
    • Air induction system that incorporates the mass airflow sensor
    • Exhaust system behind the catalytic converters.
    All E-ROD engines require a front-end accessory drive system suitable to the vehicle. The instruction manual included with each kit offers recommendations for the accessory drive kit, as well as the transmission, gear ratios and more. Chevrolet offers several configurations of accessory drive systems to suit different applications; and each allows the installer to easily delete air conditioning.
    Chevrolet Performance recommends the LS1 Engine Installation Guide P/N 88959384, which illustrates basic procedures and offers helpful tips on installing an LS engine into older vehicles.
    E-ROD systems do not come with a transmission. Chevrolet Performance recommends the SuperMatic(TM) 4L70-E - P/N 19244043 - four-speed automatic overdrive transmission, along with Chevrolet Performance's SuperMatic(TM) transmission controller P/N 19257634, for LC9 and LS3 systems. The LSA, with higher torque output, should use the SuperMatic(TM) 4L85-E, P/N 19300175, along with the SuperMatic(TM) transmission controller, P/N 19302410.
    *GM automatic transmissions are typically equipped with 40-tooth reluctor wheels for vehicle speed sensor output. GM late-model manual transmissions are typically equipped with a 17-tooth reluctor wheel. The Chevrolet Performance T56 Super Magnum six-speed manual (P/N 19329795) is equipped with a 40-tooth reluctor wheel.
    You May Also Like
    Bell Housing Kit LS and LT Engines
    $860.52
    Clutch Kit LS/LT Engines (8-Bolt Crank)
    $1,714.42
    LT1 Aluminum Automatic Bell Housing
    $176.90

  • Replaces:

    12682080, 19370671, 19418256

  • MSRP: $15,647.84
  • Discount: $2,524.55 (16.1% off)
  • Sale Price: $13,123.29
OR
Ships To
Manufacturer Warranty Minimum of 12 Months
Guaranteed Fitment Always the correct parts
Shop with Confidence Your information is safe
In-House Experts We know our products
Buick, GMC, Cadillac, Hummer, Saturn, Oldsmobile, Pontiac, Chevrolet Parts
  • GM
  • 19433063
  • 12682080, 19370671, 19418256

Details

  • Brand:

    Buick, GMC, Cadillac, Hummer, Saturn, Oldsmobile, Pontiac, Chevrolet Parts

  • SKU:

    19433063

  • Description:

    E-ROD SYSTEMS HAVE IT ALL
    Each E-ROD crate engine system carries an official California Air Resources Board (CARB) E.O. number and includes complete emissions equipment, along with the engine controller and harness needed to get the engine running. The primary elements of each kit include:

    • Chevrolet Performance crate engine
    • Engine control module
    • Exhaust manifolds
    • Catalytic converters
    • Mass airflow sensor and sensor boss
    • Oxygen sensors and sensor bosses
    • Air filter
    • Accelerator pedal
    • Evaporative emissions canister
    • Instruction manual
    E-ROD LT1 6.2L SYSTEM
    • CARB EO#: (PENDING)
    • Horsepower: 455 @ 6,000 rpm
    • Torque: 465 lb.-ft. @ 4,600 rpm
    Introduced on the seventh-generation Corvette Stingray and Gen 6 Camaro SS, the LT1 6.2L V-8 opened the next chapter in the long, historic legacy of the Small-Block engine. It is architecturally similar to the LS family of Small-Block engines, but with a unique block casting, cylinder head design, oiling system and more. It also combines advanced technologies including direct injection and continuously variable valve timing to support an advanced combustion system. Chevrolet Performance's new LT1 crate engine - offered with a wet-sump or dry-sump oiling system - and a controller specially designed for retro-fit applications is included. This is the first LT-based E-Rod system and the most technically advanced. It is also available in a Connect & Cruise package with a matched 4L75-E automatic transmission.
    INSTALLATION NOTES
    Engines shipped with high-pressure direct-injection fuel pump installed
    Assembly does not include any electronics
    Kit includes electronic throttle pedal, which is required for throttle input to the ECU
    Intended for pre-1995 street vehicles or any off-road vehicle
    Not intended for marine applications
    Front-End Accessory Drive Kit can be ordered separately
    8-bolt crankshaft flange
    Shipped with 14" flexplate
    BUILDER'S NOTE
    To facilitate a complete E-ROD installation, the builder will need to source additional components to complete the assembly and get the vehicle running, including:
    • Fuel tank
    • Fuel lines (re-circulating or returnless)
    • Fuel pump - 58 psi (400 kPa) for LC9 and LS3 or 65 psi (450 kPa) for LSA
    • Fuel tank vent line from the tank to the evaporative emissions canister
    • Purge line from the canister to the engine purge solenoid
    • Air induction system that incorporates the mass airflow sensor
    • Exhaust system behind the catalytic converters.
    All E-ROD engines require a front-end accessory drive system suitable to the vehicle. The instruction manual included with each kit offers recommendations for the accessory drive kit, as well as the transmission, gear ratios and more. Chevrolet offers several configurations of accessory drive systems to suit different applications; and each allows the installer to easily delete air conditioning.
    Chevrolet Performance recommends the LS1 Engine Installation Guide P/N 88959384, which illustrates basic procedures and offers helpful tips on installing an LS engine into older vehicles.
    E-ROD systems do not come with a transmission. Chevrolet Performance recommends the SuperMatic(TM) 4L70-E - P/N 19244043 - four-speed automatic overdrive transmission, along with Chevrolet Performance's SuperMatic(TM) transmission controller P/N 19257634, for LC9 and LS3 systems. The LSA, with higher torque output, should use the SuperMatic(TM) 4L85-E, P/N 19300175, along with the SuperMatic(TM) transmission controller, P/N 19302410.
    *GM automatic transmissions are typically equipped with 40-tooth reluctor wheels for vehicle speed sensor output. GM late-model manual transmissions are typically equipped with a 17-tooth reluctor wheel. The Chevrolet Performance T56 Super Magnum six-speed manual (P/N 19329795) is equipped with a 40-tooth reluctor wheel.
    You May Also Like
    Bell Housing Kit LS and LT Engines
    $860.52
    Clutch Kit LS/LT Engines (8-Bolt Crank)
    $1,714.42
    LT1 Aluminum Automatic Bell Housing
    $176.90

  • Replaces:

    12682080, 19370671, 19418256

Vehicle Fitment

No application/vehicle fitment information available for this product
Vehicle Fitment
Year Make Model Body & Trim Engine & Transmission
( more fitments)
No fitment data available

Product Reviews

GMOutletParts.com

GMOutletParts.com operates one of the largest and most professional GM parts warehouses in the country. Our highly experienced parts team is available to answer all of your GM parts questions and ensure your satisfaction with every aspect of your purchase.

As a  owner, you want nothing but the best to be installed in your vehicle. 

If a part is not in stock (when your order status says ON ORDER) and must be ordered from the manufacturer, it usually takes 2-3 days to arrive to us and will be promptly shipped to you. Most of the orders are shipped complete within 2-3 business days. A few of the parts ordered from the manufacturer may take up to 5-6 business days to arrive and will shipped to you immediately.

Whatever part you need, we're here for you. As a proud GM owner, you deserve to have your vehicle running at its peak performance levels. If you have any issues finding the parts you need, please contact us!

Please note Positions: Right mean Passenger side, and Left means Driver side.

Parts DO NOT COME PAINTED!

The material on this website is provided by a third party and could contain technical inaccuracies, shipping quote incorrect, inaccurate description, pricing, illustration or other errors. The illustrations in this catalog may use one illustration for both the left (driver) and right (passenger) side and are to be used as a guide only. Actual product may differ from what is shown. Please contact us for correct part numbers, part information, shipping quote or part availability prior to ordering.  This website does not reflect our current on hand inventory.  Prices on this website are for online purchases only.  This site is not owned or operated by GM.

GM

GM is the world leader in automobile manufacturing. All GM genuine replacement parts are guaranteed to meet all of the manufacturers specifications and carry the same warranty as with GM vehicles. For more information contact our GM parts staff for assistance.

Some things to remember:

Most of the illustrations contained in this online parts catalog are just simple renditions of the part and where it may be located on the vehicle, it is for reference only.

There are many factors such as trim, color, and options that will not be depicted in the illustrations.

We provide free parts fitment verification when you include your vehicle's VIN at checkout.

This GM catalog is for reference only and does not guarantee availability of parts.

GM Parts and Accessories are the best quality and are what came on your vehicle when new.